1 piece done 2 ta go

[Johnny Quest]

I did the small one by myself its 5’ long. Heavy stuff.
the other 2 are 8’ and 10’. I don’t know how I’m gunna make that happen but I will. Really nice looking stuff.
The stove slides in the slot the bar is the 8’er the sink piece is 10’. Geez this is gunna be tough.

[RapturEd]

That looks Really good JQ! Nice Job!

[Capt Mike]

Very nice

[TXXpress]

Very nice work right there.

[BDGreen]

It's beautiful.

[WhiteBassFisher]

Looks good Randal.

[Johnny Quest]

The 10’er is done on the bottom side now. I have no idea how I’m going to lift it into the counter yet. I may need a volunteer to help me.

[Shooter]

Nice talking with you the other day. If you need a hand let me know. I'm only an hour away. I'm headed back to Mexico Tuesday morning. .

[FishingTwo]

Looking good

[Johnny Quest]

Nice talking with you the other day. If you need a hand let me know. I'm only an hour away. I'm headed back to Mexico Tuesday morning. .

Thanks Breaux. I got a guy here in Crockett that wants to borrow my texture gun, so I said I’d loan it to him if he helps me set em up there. He said he would bring his helper. Lol all I have to do is supervise. Things always seem to work out.

[On The Hook]

How are you going to handle the seams? These tops tend to have chamfered edges . Do you cut the edge flat for the joint and then retouch the edges to round them slightly? Do you use biscuits or dowels? I used dowels and just butted them together once. I caulked the seam but was never really happy with the results. I’ll do it differently next time. Where did these tops come from? You’re getting there, good job.

[Johnny Quest]

How are you going to handle the seams? These tops tend to have chamfered edges . Do you cut the edge flat for the joint and then retouch the edges to round them slightly? Do you use biscuits or dowels? I used dowels and just butted them together once. I caulked the seam but was never really happy with the results. I’ll do it differently next time. Where did these tops come from? You’re getting there, good job.

I bought square edge tops just for that reason. There is only 1 butt joint in the system. I do have a biscuit joiner but don’t think I’m going to use it so it can expand and contract. I have a plate underneath to hold the butt joint together. That and construction adhesive.

[Johnny Quest]

How are you going to handle the seams? These tops tend to have chamfered edges . Do you cut the edge flat for the joint and then retouch the edges to round them slightly? Do you use biscuits or dowels? I used dowels and just butted them together once. I caulked the seam but was never really happy with the results. I’ll do it differently next time. Where did these tops come from? You’re getting there, good job.

I got them from Hardwood Lumber Company.

[beerdruid]

Dayum!!!

[Jay-Tex]

Beautiful Breaux!

[Johnny Quest]

I just love it when a plan goes thru.