OK, so I built a PC recently to run Kubuntu and FreeCAD on. Problem is, I can't get it to boot at all, not even into the BIOS configuration. It doesn't beep, just goes into a kind of power cycle loop shown in the video. I've tried another motherboard, no RAM, different RAM, no CPU, different CPU, no video card, different case and a different power supply so basically, I've swapped everything and it still does this. The only thing I can think of now is that I've got some kind of hardware mismatch but, I'm not current enough on all that stuff to know what it is. Here's what I built.
Where did I go wrong?
Where did I go wrong?
Comment